Outer Limits 4x4 Board

I know this has been covered before but can not find can someone help with this.
Starts cold first time, but hot will not start, to get it started have to cool the injector pump down with water. What was the fix and how much.

Thank

Mate get along to your nissan dealer and ask for this :- 09621-80901AU & 16826-V0700 This is a plate and o'ring . The problem is in the pump start piston area , this plate is a Nissan fix part to push the start piston to a fresh part of the bore . The plate is located on the drivers side of the pump and is eaisly accessed . Simply fit the plate and o'ring , keep the old plate as it would need to be refitted to check the pump timing . This will usually only last about 60>80000 km then you will need a new pump housing and rebuild .
Nissan came up with this to get them out of warranty before they died.

Thanks for this Hiy60 it will help alot

if you rebuild the pump now instead of letting it wear out its just a kit and not a new housing alot cheaper mine was $800 instead of the $1500-$1800 for a full rebuild ..

ask around and fine a good injector pump place it pays to ask a few differance place who they'd get to do it ..

get the nissan o ring kit and then sell it while it works its only a matter of time. kits are about $100

A good diesel shop will sell you the same part a lot cheaper, the fault is with the pump housing and this plate is a mask type affect, the only real solution is to replace the worn pump housing, cheer Phill.

The genuine part only costs $35.00 so why stuff around .