Outer Limits 4x4 Board

Just scored myself some ARB lockers for a very good price- but i have to install the buggers myself!

They are already in centres, so all i need to do is swap them over and put in the plumbing.

Now- The mess of plumbing i got from the wreckers includes a purge valve- where the hell does this thing go?

other than that, its pretty straight forwards really!

Doubler lockers, compressor, wiring and plumbing in 4.5:1 centres for $1100!

The solinoid normaly bolts into the top of the arb compressor and has the 2 wires that activate it. Did it come with the loom for it if not probaly best pick one up

Looms been hacked up and looks prettty knackered- i'll get a new one i think

Im still unsure what the purpose of the purge valve is and where it goes tho!

One Bit screws into the compressor tank the other fittting with the orange ring has the blue line run into it which runs to diff fitting and the other purge part is to vent the air out when you dis-engauge the locker some have a small filter in there which screws out (Makes it louder) which is how most are setup or you can buy a fitting that screws in there which you connect the blue line into to run a vent line to the outside of the cab if you have the compressor inside.