1hz turbo exhaust size ?
Posted: Sat Oct 18, 2008 4:13 pm
As the title say what size exhaust do people use on there's i was planing on 2 1/2 " with one straight thru muffler. Any ideas
Outer Limits 4x4 Board
Aussie Hardcore Wheelers
https://outerlimits4x4.com.au/
1hz turbo exhaust size ?
Page 1 of 1
Posted: Sat Oct 18, 2008 4:25 pm
Go a 3", mandrel bends, plumb it all on the inside of the chassis rail, good to go
Posted: Sat Oct 18, 2008 4:52 pm
This is what i'll be doing to mine soontaps wrote:Go a 3", mandrel bends, plumb it all on the inside of the chassis rail, good to go
Posted: Sun Oct 19, 2008 8:14 pm
Did similar with my 80series. 4" dump pipe to the transfer case then 3" all the way back, with one straight through muffler at the rear. all on the inside of the chassis rail.taps wrote:Go a 3", mandrel bends, plumb it all on the inside of the chassis rail, good to go
bends in the dump pipe are about 75deg, all others are 45deg max.
Was way too noisy with no muffler
Posted: Sun Oct 19, 2008 8:36 pm
to much of a good noise then?
Posted: Mon Oct 20, 2008 6:39 pm
Mines 2.5 inch mandrel bend with straight through muffler...works perfect.
Dont quote me on this but I have heard if you go to big you will loose the
power effect that an exhaust naturally generates. ....dont know how accurate this is though.
Dont quote me on this but I have heard if you go to big you will loose the
power effect that an exhaust naturally generates. ....dont know how accurate this is though.
Posted: Mon Oct 20, 2008 7:16 pm
crozza wrote:Mines 2.5 inch mandrel bend with straight through muffler...works perfect.
Dont quote me on this but I have heard if you go to big you will loose the
power effect that an exhaust naturally generates. ....dont know how accurate this is though.
Isn't that only on n/a engines? With turbo's the quicker the gas is out the quicker the turbo spools
I am goin to make my exhaust 3 1/2 inch off the turbo and run it back to a 3inch with one muffler