Outer Limits 4x4 Board

Just checked compression having done 5000k's on the new rebuild. Readings 1-2-3-4 were 180-180-180-190psi. Results were consistent for 2 separate runs.

Suzuki service manual says "200psi / 400rpm" - is 180/190psi okay? Got no idea how many rpm it's actually doing turning over without firing, but I would suspect its considerably less than 400rpm ... probably more like 250-300rpm.

Compression tester is a cheapo Trisco from Sprints ($40), so not sure how accurate it is either, but at least the relative readings should be correct.

Could be if your compression tester is a cheapo that it's out a little. Could also be that if the readings are correct, the valve clearances may be set just a little to tight causing a loss in compression. Overall though, sounds fine to me.

They sound fine.

Layto....

yeah thats good
my old motor was

170 180 125 190...

hmmmm