OK before you sledge the s#*t out of me, it was all in the name of racing that I drove the buggy without oil for a stage at SATC I won that's the main thing, but now it has a rattle in the engine, I have some thoughts as to what the problem could be, but just want to get some ideas what others think would have gone on it (bottom end or top end) what is the weakest part of the 3.9, just don't want to have to pull the lots down.
Good news is it's still running
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
3.9 EFI rattling
Moderator: Micka
3.9 EFI rattling
The Original Massojet
Check you local 4x4/Ray's Outdoors store for stock NOW
Check you local 4x4/Ray's Outdoors store for stock NOW
The rattle will be the cam lobes and followers.
These are the first wear point in a Rover engine. Even with perfect lubrication cams /chains /sprockets/and followers will be lucky to last over 160KKms and usually at 130KK.
Don't let it go too long or the lobes break up and then score the oil pump.
Bottom ends will last up to 500KK, but without oil its a lottery.
If the oil relief valve jams in them, the cam will be toast in 5Minutes.
Regards Philip A
These are the first wear point in a Rover engine. Even with perfect lubrication cams /chains /sprockets/and followers will be lucky to last over 160KKms and usually at 130KK.
Don't let it go too long or the lobes break up and then score the oil pump.
Bottom ends will last up to 500KK, but without oil its a lottery.
If the oil relief valve jams in them, the cam will be toast in 5Minutes.
Regards Philip A
I would tend to agree. Have you refilled it with oil? Drain a bit out and see if there are silver flakes/particles in it.nottie wrote:Definetly sounded like bottom end bearings to me Damo.
I had a rover (4cyl) that blew a rear main once and ran for a while with low oil. The white metal flaked off the main bearings. New set of bearings and rear main and it was good as new.
_____________________________________________________________
RUFF wrote:Beally STFU Your becoming a real PITA.
rattle
i have a 97 disco with the same motor. i was towing a caravan to coffs from newcastle. just outside of coffs i heard a noise that sounded like an exhaust leak. the rattle got a lot worse on the way home. it turned out that the oil pump screen was blocked re poor maintenance. this ment no oil was getting anywhere it should have. i was told that it was the lifters that were rattling. most times when i start it rattles for about 2-3 secs till the oil pressure builds up then its sweet. this happened a week after i got it my advice is to only buy 1 you KNOW the history of or if you can really trust the service history. hope this helps
Who is online
Users browsing this forum: No registered users and 17 guests