Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
TD5 running rough
Moderator: Micka
TD5 running rough
Gday I have a 01 td5 disco that is running like a chaff cutter, was running fine just started to do this over the last two days. Turned vehicle off and started the next day and it ran fine, drove into town turned off, when restarted ran rough again. Hoping its not a crook injector if it is how could i check thanks
Andrew
Andrew
Any trace of oil can affect the running of the engine.
The oil transfers along the injector harness into the engine harness & then eventually to the ECU.
The engine harness can usually be cleaned successfully but you'd be better off replacing the injector harness.
The oil cannot enter the ECU at all so it just needs the connection cleaned. Methylated spirits should do the job.
The oil transfers along the injector harness into the engine harness & then eventually to the ECU.
The engine harness can usually be cleaned successfully but you'd be better off replacing the injector harness.
The oil cannot enter the ECU at all so it just needs the connection cleaned. Methylated spirits should do the job.
Scott
'87 RR
'96 RR
'87 RR
'96 RR
gday firstly thanks again Scott.There is a lot of oil in the ecu connection(pulled it off and oil dripped out) and also the connection under the tappet cover (also lot of oil) small amounts in other connections. tried the metho but wouldn't successfully remove all the oil especially in the female connections is there another way to remove the oil?
Thanks Andrew
Thanks Andrew
gday thanks for all the replys. I got some co cleaner and it done a great job of removing the oil however it did not fix the problem. Ran for about 10-20 min without a problem till the car warmed up then symptoms came back ,could it be a crook injector ? if so how can I check without removing injectors, or could it be something else ? Thanks
Andrew
Andrew
Running Rough
I am not a mechanic, but do have a TD5, most recent thing we had replaced on our 2003 TD5 in a Disco with 185,000kms was the air flow meter. I did not honestly notice an issue before but running much better now. May be this will help.
Cheers,
Stinger
Cheers,
Stinger
Hello,
I had the same problem. One of the injectors was not firing. Was running on 4 cylinders. Turn off the car and start again and it would run fine for anywhere from 5 sec to 10 min, then start missing again. I checked for oil and found some on the plug under the head. There was a little oil so I cleaned if which did not make a difference. I took it to British OffRoad (I was on Fraser at the time) and they replaced the injector loom, which lives under the tappet cover in the oil. It cost about $300 including labor and I have not had a problem since.
I had the same problem. One of the injectors was not firing. Was running on 4 cylinders. Turn off the car and start again and it would run fine for anywhere from 5 sec to 10 min, then start missing again. I checked for oil and found some on the plug under the head. There was a little oil so I cleaned if which did not make a difference. I took it to British OffRoad (I was on Fraser at the time) and they replaced the injector loom, which lives under the tappet cover in the oil. It cost about $300 including labor and I have not had a problem since.
Who is online
Users browsing this forum: No registered users and 40 guests