Page 1 of 1
clutch problem.
Posted: Mon Dec 01, 2008 8:12 pm
by cspgq
is there any way to seal the clutch from water, mud and shit? im on my second clutch in 6mths.
.
Posted: Mon Dec 01, 2008 8:25 pm
by ronno88
not much else you can do but put the rubber boot on the clutch fork
and cover plate on bellhousing.
.
Posted: Mon Dec 01, 2008 8:28 pm
by cspgq
ok then. well that sucks. thanks for the reply.
mine is ok
Posted: Tue Dec 02, 2008 11:34 am
by allisterrenee
When i have a clutch done the boys in the shop put silicon all the way around the bell housing and fill the drain hole in the bottom. Also put some around the rubber boot for the clutch fork , I can sit in deep water all the time with no probs and have been doing it for years, A really good 4wd shop did it for me a long time ago and i have never looked back since,,, If you get under your car and look up at the bell housing you will see a little hole at the bottom( on a GQ) , this is one spot it comes in from alwell as the fork boot .. Hope this helps
