Outer Limits 4x4 Board

Has anyone used these extractors?
Do they really exist?
How come I can’t find anything about them on the net, anywhere?


http://www.suzistore.com.au/shopdisplay ... at=EXHAUST

I think Cj has a set but they haven't been fitted.

Steve.

It's come up on my Visa statement so it looks like there on there way.
Hopefully there good because it too late now.
They'll be here next week.
Anyway i'll keep you all posted on how i go with them.

Fitted the Extractors the other day, Bolt in my eye.
Don't get me wrong there a great product but did they just forget to finish welding them?




So after i finished welding what was forgotten I had to run them on the linisher because when I tested how flat the flange plate was with a straight edge they failed.






After all this the rest was simple, until I had to bolt the flange up under the car. It was totally the wrong size.
Apart from these little defects, there great. Noticeable power gain, and just a little more noise.

Looks OK, but....

Let's see.

The welds were incomplete, the flange wasn't flat and the bolt holes were in the wrong place.

Doesn't sound like a great product to me.

FWIW, did you notice any difference in performance?

the best way to have that stuff fitted is to take it to an exhaust shop. would be $100 to fit it properly, align flanges and weld it all up.

possible it was a g16 extractors?

Ridge wrote:the best way to have that stuff fitted is to take it to an exhaust shop. would be $100 to fit it properly, align flanges and weld it all up.

As in there ad.
when you spend $375 plus shipping and buy EXTRACTORS
(part# 14111-770EXN)
for GRAND VITARA SQ420
1998-2005 Motor J20A EFI 2.0L 4 Cyl

You would think they just fit up to a:
GRAND VITARA SQ420
1998-2005 Motor J20A EFI 2.0L 4 Cy
and not have to be modified.

I wonder if they would fit my 97 wide track j20a vitara?

TheOtherLeft wrote:
FWIW, did you notice any difference in performance?

Well down low in the rev range it feels like it pulls a little bit more, but i'll really tell this week end when I go for a drive down stockton beach.
Under a bit of load climbing some dunes I'll should know thenl.

I'll keep you posted.

They look like they were Pacemaker brand.

The flange may have been flat before the welding.

Pacemaker only list for the Swift? Unlikely they'd get them wrong for a local model- perhaps they're imported from O/S?

Liam wrote:They look like they were Pacemaker brand.

The flange may have been flat before the welding.

Nah, they were a bit bowed when I got them, don't get me wrong not a lot, but enough to worry about. The few people I spoke to said they will be Ok and that they would probably pull up but better be safe than sorry.

murcod wrote:Pacemaker only list for the Swift? Unlikely they'd get them wrong for a local model- perhaps they're imported from O/S?

they don't have their models on the website. I had a set for a v6 capri- still not on the website.