Page 1 of 1
60 series spedo cable
Posted: Sun Apr 12, 2009 3:16 pm
by RockyF75
Anyone replaced one?
Do you need to take the dash apart/off, or are there any special tricks to make it easier. I had a look from under the dash and I can see where the cable screws in but my hands are too fat to get in there
And on the gearbox end, where will it be? Haven't had a chance to look around for it yet.
Posted: Sun Apr 12, 2009 5:47 pm
by joel HJ60
Unscrew the dash face and it is held in behind the speedo via a clip. Press either side and it slides out. When your putting it back in, make sure it's clipped in by pulling on it. You don't want it to come undone after you've put the dash back in.
Posted: Sun Apr 12, 2009 5:57 pm
by RockyF75
joel HJ60 wrote:Unscrew the dash face...
There's just the two screws either side of the steering wheel aye? Or is there more?
Posted: Sun Apr 12, 2009 6:52 pm
by joel HJ60
Nagh few more. Six I think.
Posted: Sun Apr 12, 2009 9:41 pm
by Sixty's Guy
Once you get it off behind the speedo it goes through a grommet just in front of the gear stick. It then connects to the gearbox on the passenger side.
Re: 60 series spedo cable
Posted: Sun Apr 12, 2009 9:41 pm
by RAY185
RockyF75 wrote:
And on the gearbox end, where will it be? Haven't had a chance to look around for it yet.
You wont find it on the gearbox. It goes onto the transfer case, just to the left of the tailshaft flange. Simply unscrews. Might need some multigrips if its tight.
Re: 60 series spedo cable
Posted: Sun Apr 12, 2009 10:26 pm
by Sixty's Guy
RAY185 wrote:RockyF75 wrote:
And on the gearbox end, where will it be? Haven't had a chance to look around for it yet.
You wont find it on the gearbox. It goes onto the transfer case, just to the left of the tailshaft flange. Simply unscrews. Might need some multigrips if its tight.
Ah yeah, transfer case, not gearbox.....
