Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

trailer brakes with 24 vo;ts

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 2066
Joined: Mon Jun 09, 2003 8:17 pm
Location: Gympie

trailer brakes with 24 vo;ts

Post by Rhett »

can I put a brake controler unit in my import 24volt patrol and get it to work with normal trailer brakes
Its a wheelbase thing
Posts: 116
Joined: Fri Feb 02, 2007 4:46 pm
Location: maryborough QLD

Post by nisson35 »

yes but you are betteer off putting brake controler on trailer and using your brakes as power
YOU CAN FOLLOW ME BUT ITS GUNNA HURT!!
Posts: 10
Joined: Sat Feb 21, 2009 1:58 pm
Location: Mackay

Post by YOTATIM »

Most electric brakes on trailers are 12V. You can wire the brake circuit through a relay to pin 5 on the plug and install a control unit on the trailer (no adjustable in cab of course) Use a 24V relay and run 12V through the contacts this would work. Other alternitive is run 12V through relays to operate brake control unit in cab. 12V power in and relay for brake light switch 12V through contact to activate unit and then variable 12V to pin 5 for the brakes.
If you dont get through the first time you wernt goin hard enough!!
Posts: 95
Joined: Mon Feb 10, 2003 8:09 pm
Location: Traralgon

reducer

Post by RRover85 »

for reliability though I would use 24/12 voltage reducer for this kind of situation...
Posts: 11
Joined: Mon Oct 06, 2008 7:45 am
Location: adelaide

Post by jacko394 »

What sort of power requirement would electric brakes have ordinarily? what amps are fused between both wheels?(what are..fuse ratings on either actuator of each wheel?) Would you for example run a separate fuse for either wheel,so in the case of one fuse/wheel brake failing the "good" wheel still has some braking effect,whether good/bad? Or maybe one fuse blows and all trailer brakes are gone..As long as the current draw is low a 5amp 24/12 converter is all you'll need i'd say.. Cheers,Mark.
Posts: 613
Joined: Fri Oct 21, 2005 9:33 pm
Location: virginia, brisbane

Post by ausoops »

we use 12v trailer brake units on our trucks at work. we centre tap the 24v batteries to get 12v (that way you have lots of amps to play with) we then use a redarc charge equaliser to keep the batteries SOC even.
swb safari
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests