Just wondering if a TD04 turbo off a wrx would suit a 2h. My brother has finally given up on his project car and is parting it out and he has a TD04 turbo in very good condition. I can get it cheap, well he owes me a couple of dollars so its sort of free.
Just wondering if there is anyone in the know about these things.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Would a TD04 turbo suit a 2h???
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Would a TD04 turbo suit a 2h???
Electrical !!!
www.philthesparky.com.au
Offroad Photography !!!
www.offroadphotography.com.au
www.philthesparky.com.au
Offroad Photography !!!
www.offroadphotography.com.au
To work it out correctly.
you'd need to do this
Find out what the current HP is on the motor.
decide on what HP your after.
Then you'd work out the air flow required for the HP your after (maths)
Then you work out the pressure ratio (maths)
Then you use a turbo chart to work out if a turbo is correct or not, too small a turbine will retard the motor as exhuast gas won't flow properly, also this could cause the compressor wheel to spin too fast melt then go straight into the motor and out the other end.
On the other hand you could pick a turbo that's too larger and thus never produces the air flow and offer low power again but don't have the problem of the compressor wheel melting.
They are the 2 main reasons for doing the maths.
Theres a few different ways of working out the above but you might get away with it, by looking at existing kits and seeing what turbos they have and using a kit turbo map to compare with a td04 turbo map.
WRX turbos are IHI turbos which is a Mitsubishi company, they have a tri-angle exhuast mount.
you'd need to do this
Find out what the current HP is on the motor.
decide on what HP your after.
Then you'd work out the air flow required for the HP your after (maths)
Then you work out the pressure ratio (maths)
Then you use a turbo chart to work out if a turbo is correct or not, too small a turbine will retard the motor as exhuast gas won't flow properly, also this could cause the compressor wheel to spin too fast melt then go straight into the motor and out the other end.
On the other hand you could pick a turbo that's too larger and thus never produces the air flow and offer low power again but don't have the problem of the compressor wheel melting.
They are the 2 main reasons for doing the maths.
Theres a few different ways of working out the above but you might get away with it, by looking at existing kits and seeing what turbos they have and using a kit turbo map to compare with a td04 turbo map.
WRX turbos are IHI turbos which is a Mitsubishi company, they have a tri-angle exhuast mount.
Who is online
Users browsing this forum: No registered users and 89 guests