Scud Proof.
Posted: Sun May 02, 2004 11:25 pm
Put my new series 3 transfer gears in today, with the help of Nelligen (thanks). Here is a couple of photo's of our SCUD PROOF arms and mounts.
Page 1 of 1
Posted: Sun May 02, 2004 11:29 pm
A few more.
Posted: Sun May 02, 2004 11:37 pm
Last ones.
Posted: Mon May 03, 2004 12:25 am
We also modified the selector forks so you can use 2wd low. Without turning the front drive shaft.
Posted: Mon May 03, 2004 8:37 pm
a word of warning with urethane bushes might be to har and cause u lots of vibes, i no this from experience.. 
Posted: Mon May 03, 2004 11:42 pm
No problems so far, its as smooth as stock. actually smoother as its taken all the sloop out of the driveline, caused by the transfer flooping around on the rubber mounts.
I also have a total of 80mm of urethane on each bolt so it still has some movement, cushoning.
I also have a total of 80mm of urethane on each bolt so it still has some movement, cushoning.
Posted: Tue May 04, 2004 12:11 am
Bazooked xtreem has urethane bushes in place of the original mounts plus 1 on top and 1 below the mounting arms with a 100mm x 10 mm bolt going thru them , is this how you did it ?? we were a bit concerned about vibes when we fitted them but so far there working well with no vibes to be felt ,even when touching the gear lever you can't feel anybazooked wrote:a word of warning with urethane bushes might be to har and cause u lots of vibes, i no this from experience..