Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
dump pipe
Moderators: toaddog, TWISTY, V8Patrol, Moderators
I made one for my 80series.
I used some mild steel exhaust mandrel bends from a truck supplies place.
I cut a flange out of 12mm steel, cut and shaped the end of the 4" mandrel bend to fit into the flange.
Cut two mandrel bends to approx75deg to get past firewall and under the floor, I ran my exhaust between chassis rail and the gearbox in 4" tapered it to 3" at the transfer case, fitted a 14"long braided flex then 3" mandrel bends and pipe to the rear with a straight through 3" muffler at the rear. No bend is over 45 dgrees after the dump pipe.
photo was taken in the dark so its not the best
I used some mild steel exhaust mandrel bends from a truck supplies place.
I cut a flange out of 12mm steel, cut and shaped the end of the 4" mandrel bend to fit into the flange.
Cut two mandrel bends to approx75deg to get past firewall and under the floor, I ran my exhaust between chassis rail and the gearbox in 4" tapered it to 3" at the transfer case, fitted a 14"long braided flex then 3" mandrel bends and pipe to the rear with a straight through 3" muffler at the rear. No bend is over 45 dgrees after the dump pipe.
photo was taken in the dark so its not the best
Who is online
Users browsing this forum: No registered users and 1 guest