Hey Guys, long time no post..
I've got a G16B and harness from a Vitara fitted in my '97 Coilly Sierra which has been running a treat for about a year now. But recently I've been having issues with it blowing the 15A fuse before the main relay that gets 12v from the battery. Basically I'll turn the ignition on and it'll just throw the fuse straight away. I started to have a look at the relays and saw one was rusted and busted, so I replaced it with a new one. The car ran for about 10min then started throwing fuses again. I thought this must be a problem with the wire from the battery to the fuse so I have replaced that, no joy, same problem. I've gone through the harness and have found no obvious sings of rub through or breaks in the wires that would cause a short to make it blow. I did get it to run by bypassing the main relay and just running the fuel pump relay, but it wouldnt shut the fuel pump off after the 5-10 seconds that it normally does. I'm not an electrics kind of guy, so I dont know what the hell is wrong. Can anyone shed some light on this for me or supply me with some wiring diagrams? I'm hoping the ECU hasn't bitten the dust and is causing the short in there.
Look forward to some replies.
Cheers.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
G16B blowing fuel pump fuses
Without looking at it I can only give you very vague advice, but from the sounds of it to start isolating the problem, is removing all the fuses, relays and every computer and sensor you have. Then connect the main power and start shaking all the looms to try and get it to blow. If youre sure you have disconnected absolutely everything (including earths) so the harness is by itself, you could disconnect the battery and start measuring all the wiring for shorts to earth.
As I said without seeing it, its a little hard, but should get you started if you think its shorting on the chassis somewhere.
As I said without seeing it, its a little hard, but should get you started if you think its shorting on the chassis somewhere.
Who is online
Users browsing this forum: No registered users and 71 guests