Outer Limits 4x4 Board

ok so i know there may have been a similar question asked in the past, but cant find any info anywhere, so, am looking at goin spring over axle on my 60 series. its already chopped into a ute, so this is kinda the next logical step. just wondering has anyone done it and found they had drama's with the front tail shaft fouling on the gearbox crossmember.
ive already done a spring reversal on the front, moved the diff forwards significantly in the process, and found that on full droop this problem is occurring already, so had to modify the crossmember. but once i go soa, i dont think ill be able to make it all work, due to the height ill gain.
anyone got any ideas? different crossmember out there that i can use??
appreciate any help, cheers

no info you say?

http://www.outerlimits4x4.com/ftopic51966.php

Cut and turn the knuckles so your pumpkin turns up facing the t/case, and get a double cardinal joint.

i realise theres oinfo on the rest of the soa work, just saw no mention of the crossmember dramas ive experienced. but your right wozza244, turning the knuckles on the diff should solve this. hadnt looked at it this way. cheers for your help guys

Go to the "60 series bible"

I think just about any mod is covered here.

cut square section out of crossmember then section some pipe weld section did this with my previous 60 petrol 5 speed worked a treat the further you move the diff forward the less cutting on crossmember