Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
fitting bucket seats
fitting bucket seats
yes i have searched. fitted bucket seats to my gq today and they sit all weird they are a flat bottom nd i used the gq seat brackets off the old seats. Any1 had this prob? and is it legal just to make your own seat brackets up?
Blown ls1 GQ winch truck. and GU tow car / daily
Re: fitting bucket seats
If you change seats, you need to get them engineered. Paratus seats used to come with pre-engineered mounts, I hear they dont anymore.big lux wrote:and is it legal just to make your own seat brackets up?
I have looked into this as the seats in my GU are crap !
The SA authorities told me that as long as the seats/vehicle did not contain side curtain airbags I could fit whatever seats I liked, no engineering - nothing !
Not sure if all states take this position though ?
cheers
cookie monster
The SA authorities told me that as long as the seats/vehicle did not contain side curtain airbags I could fit whatever seats I liked, no engineering - nothing !
Not sure if all states take this position though ?
cheers
cookie monster
99 GU Patrol Wagon 4.2td
I went down to the local blue plate guy here he said as long as the new brackets are at least as strong as the standard ones no engineering is required but u cant just wear a harness u have to wear a seat belt on the road. but you can wear it over a harness.
Blown ls1 GQ winch truck. and GU tow car / daily
Good luck with the alignment. I have replaced the drivers seat in my GQ with a Recaro on a Bostrum Suspension base, and its a total nightmare - the seat can only go in one position relative to the width, because the recaro is wider than the standard seat, and this doesn't align with the center of the steering wheel.
The floor isn't level at the mounting points, so I have packers insterted at the moment to trim it up, and aligning the front and rear holes puts it on the piss, so out in 3 planes - should be a simple task - obviously not!
Anyway, a bit more time and material and it will get sorted, but not terribly comfortable to drive. Its pretty close now, but surprising how a small misalignment can make such a big effect to the seating position.
The floor isn't level at the mounting points, so I have packers insterted at the moment to trim it up, and aligning the front and rear holes puts it on the piss, so out in 3 planes - should be a simple task - obviously not!
Anyway, a bit more time and material and it will get sorted, but not terribly comfortable to drive. Its pretty close now, but surprising how a small misalignment can make such a big effect to the seating position.
I've made brackets up for my ute and wagon to fit Recaros and a SAAS seat.
Not terribly easy and you'll need a welder and a bit of patience. But it can be done and anything is better than a standard GQ seat.....
Not terribly easy and you'll need a welder and a bit of patience. But it can be done and anything is better than a standard GQ seat.....
Burra Boy. 1x 89 LWB wagon, turbo, frozenboost IC, lots of stuff. 1X 90 leafie ute, AXT turbo, tough as nails and about as comfie...
Who is online
Users browsing this forum: No registered users and 3 guests