Page 1 of 1
Help with Reassembling BJ42
Posted: Sun Jan 17, 2010 10:47 am
by Iava65/40
After several years of hold ups and delays I am now bolting my Landcruiser BJ42 back together. It has been a while since I pulled it apart and some of the bags have deteriorated and all the bolts and screws are in one big mess. It was also partly disassembled when I bought it. Help with bolt and screw location, photos or links to any good rebuild sites would be greatly appreciated. If you like you can email photos directly to me
njmauer@tpg.com.au
Posted: Sun Jan 17, 2010 10:58 am
by toaddog
Go and get a workshop manual
Posted: Sun Jan 17, 2010 11:34 am
by craigwanderer
toaddog wrote:Go and get a workshop manual
+1!
Also go visit the
www.ih8mud.com forum (40 & 55 series tech section)
Posted: Sun Jan 17, 2010 12:05 pm
by bj on roids
Just buy a heap or metric M6 and M8 stainless hardware and forget the stock rubbish
Posted: Sun Jan 17, 2010 1:55 pm
by AZZA'S HJ47
as bj said trow away the standard crap and buy 200m8 and 200 m6 stainless steel nuts and bolt i didnt even keep my nuts and bolts i just threw them in the bin retap any bolt hole that is tight and use plenty of never seize
Posted: Mon Jan 18, 2010 9:06 am
by beinthemud
Had the same Problem
When I did my LJ70 Had all the Bolts seperated in Boxes ,
Took them with the Engine when that was being built, They acid dipped the lot and dumped them in the same Box
Had to work on the Theory if it Fits in the Whole thats were it goes.
Still Wonder were the 10 extra Bolts I have left go