Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

40 doors

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 318
Joined: Sun Jun 07, 2009 2:31 am
Location: Brisbane

40 doors

Post by loosecanon »

hey guys stupid question, ( yea ive been searchin to no avail),
buildin a 45 series, and when i run out of materials i keep workin on the doors, till the other day i realised the sports doors ive cut and am about to weld... on the angle down bit on the inside skin curves in and isn't the same width as the rest, i figure ill just bend the bit of plate over to make it look flat, but wondering how did everone overcome this?? cheers for the idea

loooooosecanon
Top
Posts: 443
Joined: Tue Dec 25, 2007 6:03 pm
Location: Tasmania, Australia

Post by vk7ybi »

I just capped mine with some 1mm sheet.. Tacked in place, ground to follow the contour of the irregularities on the inner, then fully welded..
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 1 guest