Outer Limits 4x4 Board

hey guys... i have a problem with my high beam.... when my head lights are on low beam both are on... when i switch to high beam only the drivers side head light stays on and turns to high beam.. and the passenger side completly turns of..... but the weird thing is.. when i flash my high beam both light stay on and high beam comes in... can anyone help mi....????????????

check the relays.
next to the battery i think they are.

Mate does your high beam light on the dash still work?

Do your back ground dash lights come on when you have your headlights on? What are your tail lights doing?

It is very likely to be your light switch stalk as in hi/low beam lever.

tail lights are fine... dash lights are all good... and no the high beam indicator doest come on the dash....

yeah mine did the same it was the light witch stalk.

yeah combination switch for sure,

i found bursons was cheap for brand new ones in my old hilux

Just pull the stalk off the stearing collum and give it a clean and clean the contacts with emery paper, piece off cake to do. Once you pull the stalk assembly there is a white/clear plastic on the back of it that can be pulled off (should be melted stalks holding it on kinda thing) under that are all the contacts. If you'r running higher powered headlights fit relays, it'll extend your switch's life span too.

cheer heaps guys

I have similar problem except both lights turn off when high beam get's fired up. Have been too busy to look into it but I might get excited and check the stalk this week.

pull apart/clean out/contact cleaner are the go. happens a bit on the gq's apparently