Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

tube bar

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 46
Joined: Mon May 28, 2007 8:24 pm
Location: dubbo

tube bar

Post by Team80 »

hay all im thinking off makeing a tube bar for the front off my 80 series and was just wondering what thicness plat to use for the winch cradle and thicness tube to use (useing 3in pipe)
Top
Posts: 5256
Joined: Fri Jun 16, 2006 6:49 pm
Location: Melbourne

Post by Struth »

I would use 4mm plate with suitable gussets for the cradle.

But a lot of people would probably recommend 6mm.


If you are bending the tube it will probably need to be a minimum 4mm thick in 3" diameter.

Mine is 4mm cradle with 2" x 4mm bent tube and it doesn't budge for anything.

Just my thoughts.
Top
User avatar
Guy
Posts: 10366
Joined: Thu Dec 12, 2002 8:43 am
Location: Wangaratta

Post by Guy »

I would most likley buy one on the Warn winch plate thingamjiggers ...

http://www.warn.com/truck/mounting-syst ... unts.shtml

Then fab up a bar around it.
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests