Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

calipers pushing back on hard high speed cornering

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 25
Joined: Sat Dec 26, 2009 11:57 pm
Location: brissy

calipers pushing back on hard high speed cornering

Post by boost is good »

my calipers pushing back on hard high speed (over 80kph) cornering, only seems to happen on right handers. its a gq twin cab with 33x12.5/15s on 10 inch rims. wheels bearing are good and correctly adjusted .. is it possible for spindles to flex? any ideas? seen it before? :?
thanks
Posts: 1258
Joined: Wed Mar 21, 2007 7:49 pm
Location: Mornington/ Victoria

Post by PGS 4WD »

Check wheel bearings again. They loosen up with big tyres all the time.
-Pre trip inspections/ servicing
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
Posts: 25
Joined: Sat Dec 26, 2009 11:57 pm
Location: brissy

Post by boost is good »

PGS 4WD wrote:Check wheel bearings again. They loosen up with big tyres all the time.

have done .. still does it (straight up).. even tried slightly overtightening them , no better
Posts: 1039
Joined: Mon Mar 05, 2007 10:28 am
Location: On board the Mothership

Post by Harb »

I would replace the wheel bearings.....you may have an incorrect cup/cone pairing.
Harb

http://www.4wdmonthly.com.au/shed/index.php?id=2244&im=1
Posts: 25
Joined: Sat Dec 26, 2009 11:57 pm
Location: brissy

Post by boost is good »

PGS 4WD wrote:Check wheel bearings again. They loosen up with big tyres all the time.
:oops: you were right .. it was the left rear wheel bearing ..

thanks for the help
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests