Page 1 of 1
calipers pushing back on hard high speed cornering
Posted: Tue Mar 30, 2010 9:14 pm
by boost is good
my calipers pushing back on hard high speed (over 80kph) cornering, only seems to happen on right handers. its a gq twin cab with 33x12.5/15s on 10 inch rims. wheels bearing are good and correctly adjusted .. is it possible for spindles to flex? any ideas? seen it before?
thanks
Posted: Tue Mar 30, 2010 10:04 pm
by PGS 4WD
Check wheel bearings again. They loosen up with big tyres all the time.
Posted: Wed Mar 31, 2010 10:13 pm
by boost is good
PGS 4WD wrote:Check wheel bearings again. They loosen up with big tyres all the time.
have done .. still does it (straight up).. even tried slightly overtightening them , no better
Posted: Wed Mar 31, 2010 10:45 pm
by Harb
I would replace the wheel bearings.....you may have an incorrect cup/cone pairing.
Posted: Fri Apr 09, 2010 8:59 pm
by boost is good
PGS 4WD wrote:Check wheel bearings again. They loosen up with big tyres all the time.
you were right .. it was the left rear wheel bearing ..
thanks for the help