Page 1 of 1

drive flange seal

Posted: Tue May 11, 2010 3:28 am
by mad-marc
Hey there folks,
I was wondering how to exchange the drive flange seal in the front diff of a y60 since it is leaky.
Can I just loosen the locknut and pull off the flange or wil my pinion drop out?

n

Posted: Tue May 11, 2010 9:30 pm
by Clanky
Its easy
Take the load off the diff (unlock the hubs or jack it up) gears.
remove tailshaft
big pipe on socket as its fairly tight - I made a flat bar with some bolts to lock the drive flange and rested the end on the ground to hold it steady
rip out seal
fit new seal

I did both mine recently - no dramas.

Oh, go the genuine seal as the aftermarket ones were not the same. I paid $29 each from Nizzbits

Posted: Wed May 12, 2010 2:15 am
by mad-marc
thanks a lot.
I got the seal (also OM part) an will try it some time this week.