Hey guys, is there much in installing a set of extractors apart from bolting them on etc?
Cheersssss
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
extractorzzzzzzz
Moderators: toaddog, TWISTY, V8Patrol, Moderators
use plenty of penetrating fluid on the nuts. not the kind you use on the missus - wd40 or inox.
Use new studs as said, and remember not to overtighten them. They are only done up lightly about 25 foot pound or so. If you tighten them too much they will expand with the heat and snap.
Throw in a new gasket too.
You may break some old studs, so have screw/stud extractors and drill bits on hand incase.
I'll assume you're taking it to an exhaust place to connect it to the rest of the system, or replace it, since you're asking this question. Good way to save some cash as taking off the old junk can be the trickiest part to do.
Use new studs as said, and remember not to overtighten them. They are only done up lightly about 25 foot pound or so. If you tighten them too much they will expand with the heat and snap.
Throw in a new gasket too.
You may break some old studs, so have screw/stud extractors and drill bits on hand incase.
I'll assume you're taking it to an exhaust place to connect it to the rest of the system, or replace it, since you're asking this question. Good way to save some cash as taking off the old junk can be the trickiest part to do.
The worst part about being told you have Alzheimer's, is that it doesn't just happen once.
Who is online
Users browsing this forum: No registered users and 8 guests