Outer Limits 4x4 Board

Hey

Chasing a 4.3 high pinion front centre for a lux. Are they from the bundys? If so what year and engine?
Also will it bolt straight in no mods needed?

Cheers Justin

I think you will find an 80 series diff centre is high pinion and will bolt into your solid axle diff.

Bundies and 80's. They will fit with no mods.

Sweet, thanks guys. So what has the 4.3s, dsl or petty cruiser or bundy?

justinshere wrote:Sweet, thanks guys. So what has the 4.3s, dsl or petty cruiser or bundy?

all 105's are 4.3 high pinion.. ALL 80's are 4.1's dunno wat ratios bundys were

crankycruiser wrote:

justinshere wrote:Sweet, thanks guys. So what has the 4.3s, dsl or petty cruiser or bundy?

all 105's are 4.3 high pinion.. ALL 80's are 4.1's dunno wat ratios bundys were

The Bundy i stripped was 4.11 petrol

80gus wrote:

crankycruiser wrote:

justinshere wrote:Sweet, thanks guys. So what has the 4.3s, dsl or petty cruiser or bundy?

all 105's are 4.3 high pinion.. ALL 80's are 4.1's dunno wat ratios bundys were

The Bundy i stripped was 4.11 petrol

And I've heard of bundys also being 4.88

Some of the bundies did have 4.3's and also the 105 cruisers Petrol and non-turbo desiel's.

I run a 4.3 high pinion in my lux.

No mods needed. Run the same air locker as low pinion.

Willy Hilux wrote:Some of the bundies did have 4.3's and also the 105 cruisers Petrol and non-turbo desiel's.

I run a 4.3 high pinion in my lux.

No mods needed. Run the same air locker as low pinion.

Just with what you have said above to clarify something...

Bundies would run the same lokker as the lux 4cyl low pinion centre (same size bearings) but not 80/105 series. These have bigger bearings, but are the same as a V6 lux centre.

And as said, all bolt up fine, no mods.

Brad

Ok. Thanks for all the info.

Off to the wreckers tomorrow.

petrol bundy should be 4.30, mine is anyway

and can run the large bearing lockers, you just need the new bearings

pozman wrote:petrol bundy should be 4.30, mine is anyway

and can run the large bearing lockers, you just need the new bearings

"You just need new bearings"... From an 80 or 105?

To clarify no 80s have 4.3s?

Same as pozman, Petrol 4.3 and Diesel 4.88.
Newer/current ARB RD132 fits all Toyota HP & LP 8" centres.

justinshere wrote:

pozman wrote:petrol bundy should be 4.30, mine is anyway

and can run the large bearing lockers, you just need the new bearings

"You just need new bearings"... From an 80 or 105?

To clarify no 80s have 4.3s?

Definatly NO 80's had 4.3's. all 105's were 4.3

yeah i think there just the later model bearings, they list the part number in the airlocker fitting book

as far as i know all cruisers, (real ones) are 4.11, but some one may know better than i

paul