Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

One Glow Plug Replaced = new engine!

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

One Glow Plug Replaced = new engine!

Post by Shadow »

Tested my glow plugs on the weekend and found that one was fubarred.

replaced it with a Bosch unit ($15 repco) and she starts so much better now.

previously it would blow a crap load of white smoke and miss and carry on for about 20-30 seconds.

now it starts buetifully again. Cant believe the difference it made!.

Reason i suspected a glow plug was because it started much better during summer and i didnt think the engine could have degraded so much so quickly.


is it worth while replacing all the plugs? the others tested fine. All read around the 0.2 ohm mark. Did not think to compare the bosch glob plug's resistance, but figure it would be different anyway being a different brand.
Posts: 4737
Joined: Wed May 12, 2004 10:39 pm
Location: Brisbane

Post by De-lux »

is that all they cost?? i was under the impression that they costed about $80 each. in that case, i might go and replace all of mine
indubitably
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Post by Shadow »

De-lux wrote:is that all they cost?? i was under the impression that they costed about $80 each. in that case, i might go and replace all of mine


thats all the cost for my hj60 (2H) anyway

the toyota part was $44 making the bosch unbits much more affordable :)

repco did have a 25% sale on, that would make em $20ea normally.

im sure you can get them cheaper than repco though!
Posts: 129
Joined: Tue Oct 28, 2003 5:03 pm
Location: Sydney

Post by Rough60 »

yep i paid 20 2 weeks ago
Posts: 9
Joined: Sun Feb 29, 2004 11:19 pm
Location: Drewvale

Post by mudhag »

How do you test glow plugs? got a mate with a problem that sounds very similar!
Go with your Ambitions instead Of your Capabilties....
Posts: 6029
Joined: Tue Dec 24, 2002 9:34 pm
Location: South Australia

Post by bad_religion_au »

mine are fubared as well, problem is i replaced em with bosch last year (before snow season/) and their buggered again... is it natural to have to spend $120 a year on glowies? all but one is stuffed, i gotta boil the saucepan full of water to start the soab
Spit my last breath
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Post by Shadow »

mudhag wrote:How do you test glow plugs? got a mate with a problem that sounds very similar!


take the strap off them (strap of copper/brass that connects them all together, voltage rail)

and put a multimeter on each one, they should all ready very similar resistance (ohms).

if they read very large resistance (open circuit) they are fibared

mine all read 0.2 ohms except one which was open circuit (dead).



bad_religion_au wrote:mine are fubared as well, problem is i replaced em with bosch last year (before snow season/) and their buggered again... is it natural to have to spend $120 a year on glowies? all but one is stuffed, i gotta boil the saucepan full of water to start the soab


well my glow plugs have never been replaced until i just did the single one. Thats 14 years of operation without failing..... If the bosch units fail much quicker i guess we can only say you get what you pay for :( Toyota ones may infact be worth it in the long run?
Posts: 129
Joined: Tue Oct 28, 2003 5:03 pm
Location: Sydney

Post by Rough60 »

i've been told if you whip out the plug and run it across your batt it should glow like a heater, is this true for 6V plugs in my hj60
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest