I have 2002 mitsubishi chalanger. the gear box has just been rebuilt, 6 weeks ago, and now the four wheel drive on the dash board flashes constantly,and will not go out.
i have tried shifting into 4wheel low, and 4wheel high drive, then back into 2 wheel drive but the light still flashes
any ideas will be greatfully recieved
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
chalanger
Moderator: -Scott-
Re: chalanger
Ok Guy,
Get yourself under it and check out the linkages and vacuum pipes, for the front wheel drive, the arm is proberly stuck with rust and crap and needs manually working in and out and lightly greaseing, see whats behind the rubber covers have a nice day, under there.
Get yourself under it and check out the linkages and vacuum pipes, for the front wheel drive, the arm is proberly stuck with rust and crap and needs manually working in and out and lightly greaseing, see whats behind the rubber covers have a nice day, under there.
Re: chalanger
Whoever rebuilt the gearbox probably didn't reconnect the electrics to the vacuum servos for the 4WD. Take it back to the repairer and egt them to check it out.
Re: chalanger
It's more likely that the super-select switches on the transfer case were either not connected, or re-connected incorrectly, so the module driving the lights can't make sense of the signals.
You need to find a wiring diagram showing which wires connect where, then crawl underneath and confirm they're all connected correctly.
You need to find a wiring diagram showing which wires connect where, then crawl underneath and confirm they're all connected correctly.
Who is online
Users browsing this forum: No registered users and 0 guests