Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Tailshaft Spacer
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Tailshaft Spacer
I need a tailshaft spacer to be made for the rear propshaft of my 94 Paj. Does anyone know of somewhere in Melbourne i may be able to get one turned up. I have made a template and know the bolt spacings etc, i just need someone with a lathe and a square drill press to make one up for me. I have looked into the Snake racing ones and none of the bolt holes are the same. Any ideas? Cheers.
Re: Tailshaft Spacer
would the triple drilled ones from locktup have the right spacing?
Keep it shiny side up!
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Re: Tailshaft Spacer
I'm not sure. A work mate bought a spacer from Snake which had different hole spacings machined into it (Toyota), however none matched. The centres are 60mm x 70mm. I have e-mailed locktup and a few others, so i will see what they have to say i suppose.
Who is online
Users browsing this forum: No registered users and 0 guests