Outer Limits 4x4 Board

Hi All,

Rebuilding my front axle and I am at the point of putting the new seal which sits on the back of the stub axle. How do you press the seal on all the way to stub plate with out fouling up the seal lips?

Just take a rubber mallet / chunk of wood to her and she'll be right (removing the spring first)?

Cheers

thats how i did mine, and lube up the back of it (stub axle side) so it slides on a little easier, probably not the best way to do it but it works just gotta be careful while your doing it not to belt it too hard.

also be careful not to get too frustrated when it doesn't go in and then you try and smash it in