Page 1 of 1
help need new 11x1 pitch nuts for an 80
Posted: Sat Sep 24, 2011 12:44 pm
by howsie
So these nuts are from the transfer end if the driveshaft. Apart from Toyota can anyone recommend anywhere to get these from. I have been to three bolt specialists and they say it isnt a common size and Toyota may be the inly place and as Toyota probably think 5 bucks a nut is a fair price was looking at alternatives.
Re: help need new 11x1 pitch nuts for an 80
Posted: Sat Sep 24, 2011 1:11 pm
by Ice
buy a tap and some hex bar and make your own ?
Re: help need new 11x1 pitch nuts for an 80
Posted: Sat Sep 24, 2011 1:26 pm
by Z()LTAN
toyota are cheap for these kinds of parts bro... shouldnt be more than a dollar each...
Re: help need new 11x1 pitch nuts for an 80
Posted: Sat Sep 24, 2011 3:43 pm
by 80's_delirious
Z()LTAN wrote:toyota are cheap for these kinds of parts bro... shouldnt be more than a dollar each...
I've found the same, Toyota seem to use fine thread pitch a lot which are rarely used in general engineering. I've been surprised a couple of times to find Toyota have had what I wanted on the shelf and at a reasonable price.
Sometimes its easier than chasing around to save a couple of $ for a few bolts
there is an engineering fasteners supplier a Kirawee i've had good success rate with in the past, bit of a drive from The Riff though
