Outer Limits 4x4 Board

Im going to install new ball joints (upper and lower). Can i do it without taking the brake calipers off and the knuckle? Any tips would be great so i can save time

In what?

Are they bolt in or press in?

In 1990 Feroza and they bolt on.

chugga wrote:In 1990 Feroza and they bolt on.

You should be able to. Most ball joints wii come apart at the knuckle & the n un bolt them from the swing arm. Do them one at a time so the kuckle does not fall down & strain the brake hose.

From memory you don't require taking off caliper, a good size hammer and ball joint separator is a must but...

Thanks for that. It pays to ask some one who has done it.

Chugga,
I just remembered I did end up unbolting calipers, so that I dropped out the ball joints I wouldn't stretch the break lines, that way I toed it up out of the way, pretty quick to get them off and makes job a little easier.

Thanks Percy all the info means less time under the car

It was easy to change the ball joints. All you need to do is take the brake caliper off the rest is basic. What a improvemnt new ones make!!