Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Rear Disc Brakes - HELP - URGENT

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 9
Joined: Sat Nov 08, 2003 12:23 pm
Location: Perth WA

Rear Disc Brakes - HELP - URGENT

Post by flano »

All.
INFO needed urgently. How do you properly compress the brake calliper piston for rear disc brakes where the parking brake actuates the disc brakes via a lever arm (NOT a small drum setup inside the disc rotor). Just CAN NOT compress the pistons far enough to fit the new pads in. Need the Paj back on the road (like yesterday) so the right "tech tip" will be most appreciated.
Thanks,
Sean.
'88 NF SWB Intercooler TD, LSD (retired hurt), swaybays (in the garage), 6000lb winch, 2" suspension lift, 31x10.5R15 Goodyear Wrangler MT/R's, Shopping List (LONG).
Top
Posts: 14209
Joined: Sun Jan 11, 2004 11:36 am
Location: Adelaide

Post by -Scott- »

It's not a matter of backing off the adjustment on the handbrake mechanism?
Top
Posts: 2739
Joined: Sat Oct 26, 2002 7:50 am
Location: Melbourne

Post by Bitsamissin »

Yeah just open the bleeder nut to allow the fluid to exit as you push the pistons back. A brake bleeder kit (about $10) helps do this or just the right diameter tubing into a orange juice container will do the trick.
I just luv my "clacker Jabber"
Top
Posts: 124
Joined: Thu Jan 02, 2003 9:34 pm
Location: Tyers

Post by Pharb »

May need to rotate the pistons, ie screw them back into the caliper. This is how alot of disc type service/park brake assemblies worked.

Peter H
NJ Pajero 2.8TDI
Top
Posts: 9
Joined: Sat Nov 08, 2003 12:23 pm
Location: Perth WA

Post by flano »

Pharb was on the money,
Pistons have two recesses in them. After modifying a 15mm socket with my favourite tool (4" grinder), I was able to wind the pistons all the way back in. I also found that it helped to turn the Park Brake levers all the way round to lock whatever was inside the piston. Without doing this the pistons just turned but did not retract.
:armsup:
Sean.
'88 NF SWB Intercooler TD, LSD (retired hurt), swaybays (in the garage), 6000lb winch, 2" suspension lift, 31x10.5R15 Goodyear Wrangler MT/R's, Shopping List (LONG).
Top
Post Reply

Return to “Mitsubishi”

Who is online

Users browsing this forum: No registered users and 1 guest