Outer Limits 4x4 Board

Hi my glow plug controler on my hj47 2H engine has died and i put a manual control button in which in turn has burnt out my glow plugs, wat have others done to overcome this problem, can i fit higher rated glow plugs as these were 6 volt ones

thanks Shane Mulcahy

my old man just put in a spring loaded toggle switch in his truck has been trouble free for over a year now ..

Put a push switch or the like on it and on'y glow it for about 2-5 seconds.

you must only glow for about 3 seconds at 12volt or you melt the glow plugs.

Later 2H has 12V (well 11V) glow plugs, if you have it hooked up to a manual switch you should be able to fit these so you dont melt them. Just make sure you use a heavy relay wit the switch, otherwise the switch will burn out in no time.