Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

PTO Winch

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 18
Joined: Wed May 26, 2004 9:17 am
Location: Christchurch New Zealand

PTO Winch

Post by red devil »

Does anyone know if a Gen1 1986 parjio PTO will fit on to a 91 PARJIO softtop superselect
92 vx landcruiser
4" supension lift
1" body lift
35" MT wangers
Top
Posts: 2739
Joined: Sat Oct 26, 2002 7:50 am
Location: Melbourne

Post by Bitsamissin »

The problem you will have is the idler gear in the t/case (where the hatch is) mating to your PTO drive gear.
The 86 Paj will have a ratio of 1.944:1 the Gen 2 has a ratio of 1.925:1.
I have never seen a factory PTO on a Gen 2 :?:
I just luv my "clacker Jabber"
Top
Posts: 18
Joined: Wed May 26, 2004 9:17 am
Location: Christchurch New Zealand

Post by red devil »

oooooo bugger. Thank you for that information.

am i able to change the gear on the input shafe for the PTO so that it will work.
92 vx landcruiser
4" supension lift
1" body lift
35" MT wangers
Top
Posts: 2739
Joined: Sat Oct 26, 2002 7:50 am
Location: Melbourne

Post by Bitsamissin »

I the input gear on the PTO shaft able to be removed ?
If it is a gearcutter could cut a new run that will run with the 1.925 idler gear in the t/case but he will need an idler gear as well. It would cost several hundred $$ for a one of gear cut.
Honestly I would just bung in a Warne 8000lb low mount for the cost and stuffing around with the PTO which has a much lower line pull rating.
I just luv my "clacker Jabber"
Top
Post Reply

Return to “Mitsubishi”

Who is online

Users browsing this forum: No registered users and 2 guests