Page 1 of 1
PTO Winch
Posted: Mon Aug 02, 2004 7:45 am
by red devil
Does anyone know if a Gen1 1986 parjio PTO will fit on to a 91 PARJIO softtop superselect
Posted: Tue Aug 03, 2004 6:14 pm
by Bitsamissin
The problem you will have is the idler gear in the t/case (where the hatch is) mating to your PTO drive gear.
The 86 Paj will have a ratio of 1.944:1 the Gen 2 has a ratio of 1.925:1.
I have never seen a factory PTO on a Gen 2
Posted: Fri Aug 06, 2004 9:21 am
by red devil
oooooo bugger. Thank you for that information.
am i able to change the gear on the input shafe for the PTO so that it will work.
Posted: Fri Aug 06, 2004 5:45 pm
by Bitsamissin
I the input gear on the PTO shaft able to be removed ?
If it is a gearcutter could cut a new run that will run with the 1.925 idler gear in the t/case but he will need an idler gear as well. It would cost several hundred $$ for a one of gear cut.
Honestly I would just bung in a Warne 8000lb low mount for the cost and stuffing around with the PTO which has a much lower line pull rating.