Outer Limits 4x4 Board

Just wondering if anyone knows how to remove the lower output gear from main shaft. IE what side? The flange side or the other?

yea it comes off from the flange end.

nelligen wrote:yea it comes off from the flange end.

Thanks I'll keep trying. I have only got a gear puller not a press do you think it will work?

i used a pull when i removed all of my gears from the shafts. but i can remember how tight they were, all i can say is that they all eventually came off.

I had to set it up with the gear resting on a few wooden blocks then knock the shaft down with a hammer and an alloy dolly, it came off easy with no damage, just take it easy

Thanks guys I ended up using the puller.
Just keep cranking till I had the big bang effect and all was good.