Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Rust in SWB Sierra

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Forum rules
Post Reply
Posts: 1041
Joined: Wed Jan 07, 2004 1:09 pm
Location: Melbourne, Victoria

Rust in SWB Sierra

Post by Mudzuki »

Im sick of looking at the rust and need advice. The area that has rust is the strip of metal that holds the tailgate seal. The previous owners used it for hobby farm animal transport and it ended up trampled down.

I have gone over it with a wire brush to remove a heap on the surface after pulling the seal off, and there is now quite a rough edge. Should i cut it off and weld on some angle section to hold the seal, or try and save what little metal is left and weld some strip onto that?

Or should i take it to a panel beater and get them to do it?
Top
Posts: 215
Joined: Sun Jul 18, 2004 2:34 pm
Location: Tassie, Australia

Contact:
Contact 85zook

Post by 85zook »

try looking round the wreckers for a rust-free tailgate before you start doing any hard work on the current one. would definitely save youself some time and effort if you could find one.
Top
Posts: 2817
Joined: Fri Feb 21, 2003 10:10 pm
Location: Hellbourne again

Post by bigsteve »

The strip that holds the seal is part of the body.

This was totally shagged on my tin top, but is perfect on my soft top (WFT?)

I'd grind it flat with a flap disk and live without a seal.

Note the seal is just a water/mud trap.
yeshemesh
Top
Posts: 2001
Joined: Wed May 26, 2004 9:47 pm
Location: sydney

Contact:
Contact runnin4life

Post by runnin4life »

seeing as were talking about rust i have some rust in my soft top its on the back gaurd its on the strip thats is bent under and the inner guard it connected to can i just cut it off and weld a little bit of strip metal and etc or easier to cut that part out of another sierra


might see if i can get a pic up
Top
Post Reply

Return to “Suzuki”

Who is online

Users browsing this forum: No registered users and 2 guests