Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Assistance required with Volvo Portals

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 14
Joined: Wed Jun 09, 2004 12:50 am
Location: Cape Town

Assistance required with Volvo Portals

Post by MikeMac »

Hi

Forgive my ignorance, but I have a question on removing the axle shaft and CV from the Volvo portal. I have remove hub form the swivel housing(excuse the terminology) and removed the rubber CV boot. However the CV and shaft will not cone out of the hub. I assume that you need to remove the "plug" on the wheel side of the hub to remove the CV and shaft. As I am in South Africa, it is difficult to get parts so I do not want to damage the "plug" if i don't have to.

Any suggestions appreciated.
Top
Posts: 705
Joined: Thu May 13, 2004 7:29 pm

Post by daddylonglegs »

No Mike you dont remove the plug. The outershaft of the CV has an internal spring ring{circlip} that expands into the portal gear. I remove the CV's with a tyre lever between the swivel housing and CV bell and tapping [belting } the swivel with a heavy copper faced hammer.
Bill.
Top
Posts: 14
Joined: Wed Jun 09, 2004 12:50 am
Location: Cape Town

Post by MikeMac »

Thanks Bill. I will try that.
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 3 guests