Page 1 of 1
SWB patrol utes
Posted: Wed Sep 29, 2004 9:14 pm
by SWBmav
I am looking at geting my Swb maverick cut down into a ute, can any body send me some picks of different type of cut down's because i havn't seen many. Also if any body can tell me just how much it cost's to get it done.
Re: SWB patrol utes
Posted: Wed Sep 29, 2004 9:38 pm
by bogged
Call Sandy at Aus4wd in Bayswater.. hes the guru of it.
Cost.. lots of thousands.
Posted: Wed Sep 29, 2004 9:56 pm
by Big Red Toy
buy me a 9" grinder & i'll do it for free.
Posted: Wed Sep 29, 2004 10:03 pm
by Justin_M
MQ body swap? hehe
Posted: Thu Sep 30, 2004 8:22 am
by GQ TROL
http://forum.patrol4x4.com/photos/index.php?cat=10239
The last 3 pics are of two GQ tray-back utes that kick around on the NZ winch challenge circuit.
Cheers
Mitch
Posted: Thu Sep 30, 2004 8:27 am
by big red
Posted: Thu Sep 30, 2004 9:16 pm
by SWBmav
Thank for the pic's they look great.And i have a 9 inch angle grinder to, and i have throught about doing it myself but i have done a suzuki before and there is alot of work in it. Also i what to keep it a little bit legal to. I've decide on get it cut down into a tub back ute. I am also get a 5 inch spring lift at the same time. so i will post some pic's when I get it done.
Posted: Fri Oct 01, 2004 8:41 am
by bru21
too easy mate. just don't make it too heavy. a lot of the fellas make the rear tail gate weigh nearly 100kgs. keep it light or you are wasting your time.
cheers mate
bru
Posted: Fri Oct 01, 2004 12:07 pm
by chimpboy
It might not hurt to take a good look at an MQ SWB body... if only for ideas, but quite possibly for parts. You could probably do it carefully in a way that would let you use an MQ canopy easily.
Jason
Posted: Fri Oct 01, 2004 8:04 pm
by SWBmav
I got a MQ tail gate for it for only $50 in good cond.