Outer Limits 4x4 Board

looking at putting some 40series diffs on my 85 model hilux

now i know guys have done this b4, how did you address where the diff centre is, as its, well, not in the centre

anyhting else i should be aware of b4 i get started too?????

dont worry about it

as long as the output on your t-case and the pinon flange of the diff is at the same angle, it will work no worries with no vibration

cool, is it really that easy???

guess i'll get started as soon as i get back then

If you have say a centered diff axle in the rear on a pickup and you use a crusier trans with the output to the right like the 55 yes it goes to the right a bit, angle down is still the same so it would work fine? Or am i just to far gone!

I thoght that the 60 series diffs were stronger?

Is there a prob using them?

60 diffs are a few inches wider, and have strengthening if they are the 87 or later 60 diffs.
Andrew

Elmo wrote:looking at putting some 40series diffs on my 85 model hilux

Just curious but WTF are you doing that for?

robs a drunk nut bar at the best of times, no he has these diffs and already with cross over high steer done and have 6.1's already installed for the 37 mtr's

the 6.1s wont last very long with the 37s

Elmo wrote:cool, is it really that easy???

Yes it is

im mainly doing it cause like simon said, i have these sitting in my garage already, they've already got hi steer, 6.1's and lockers in em, i figure i may as well use em if i've got em, although yes 60 series would be nice but then so would 80 series diffs or even patrol ones too

why dont you reckon the 6.1's would last with the 37's???