Page 1 of 1
gu rear tail shaft(re-tubeing)
Posted: Fri Apr 04, 2003 7:31 pm
by thunder
ok rang up a couple of places up that repair and balance these.
1 place said that the tube for a gu isnt available in australia and would be too hard to do..
another said he could do it for $350 bucks
and another i need an interpreter to understand what hes on about..
question is has anyone had 1 retubed or know how much could i expect to pay for it...thanks in advance ....steve
Posted: Fri Apr 04, 2003 11:38 pm
by big red
see if a GQ one will fit.
A mate got his modified and used chrome moly, hasn't had it on road yet though.
Posted: Fri Apr 04, 2003 11:41 pm
by big red
btw, the 2.8td GU ones have different flanges, not sure about GQ ones.
Posted: Sat Apr 05, 2003 7:40 am
by thunder
i asked nissan how many part numbers there were for the rear tail shaft on the GU.
the answer was 9 its also different from the auto and manual.
Posted: Sat Apr 05, 2003 8:13 am
by Wendle
get the $350 dude to show you the material he is going to use, if it looks good and strong, try and get him to do it for less $
Posted: Sat Apr 05, 2003 1:01 pm
by thunder
...dont u think it is expensive when i hear other makes r about 200 bucks
Posted: Sat Apr 05, 2003 5:43 pm
by Surfection
Is that from the place i told you to ask stevo ??
Posted: Sun Apr 06, 2003 12:54 pm
by thunder
Surfection wrote:Is that from the place i told you to ask stevo ??
no jeremy ,,that 1 said he cant get the tube in australia and its too hard to do.......
Posted: Sun Apr 06, 2003 7:32 pm
by thunder
i went and got another shaft from the wreckers ,cause i dont want to pay 350 bucks for the little bit of damage i got to the shaft..
ill drive to the jambo on the good shaft and ill use the slightly damaged one in the comp .(and then maybe ill pay 350 for it to b repaired after its really f@#@#d)
Posted: Mon Apr 07, 2003 12:16 pm
by vrunner
I have a brand new GU shaft sitting in the shed that you can have for a couple hundred if you want. It came out of a auto "TI" wagon with 4.5 petrol engine. I'm also selling the locker diff if your interested.
Posted: Mon Apr 07, 2003 1:41 pm
by Shorty40
Steve,
I know its not a GU, but I just got my rear shaft done. Good job and it was cheap.
Can't thiink of their name atm, will let you know tonight
Dan
Posted: Mon Apr 07, 2003 4:38 pm
by thunder
vrunner wrote:I have a brand new GU shaft sitting in the shed that you can have for a couple hundred if you want. It came out of a auto "TI" wagon with 4.5 petrol engine. I'm also selling the locker diff if your interested.
the only shafts that fit mine are from 3.0td manuels.....asked nissan there are 9 different part numbers on the gu shafts
Posted: Mon Apr 07, 2003 9:10 pm
by big red
just weld your old one up with some thick tube and keep it for comps only.