Hey guys need some advice.
My mech dropped in a complete Discovery 3.9 V8 (1996) with the transmission and transfer case into my old 1989 Range Rover.
Now i've got a problem with engaging low range. It seems that after abit of searching there is some sort of lock out mechcanism. So how do i go about rectifying it? Any solutions or does anyone know how to get rid of it? Or dont tell me i need to drop the fecking gearbox to bin the solenoid? Can someone give me a brief through so that i know what i can tell to the mechanic?
Also another small problem is does anyone know how to rectify my fuel guage? Coz now i'm using the meters from the Disco and the fuel guage is under reading. Hence it shows i have an empty tank when probably i might have 1/3rd of fuel. So any suggestions how to rectify this problem.
Any advice is greatly appreciated.
Thanks in advance
Best Regards
Vic from Malaysia
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
trasfercase problem(*new* fuel guage reading problem)
Moderator: Micka
trasfercase problem(*new* fuel guage reading problem)
Last edited by BabyGodzillaGTi-R on Thu Jan 20, 2005 4:21 am, edited 1 time in total.
My RIG sucks big time.
what is the transfer case serial number ?
if it starts 40D, this is USA / Japan spec in which case you have the shift interlock which stops you cnahging from hi to lo unless in Park or Neutral, if this is the case you need to remove the 4 small bolts holding the 40mm round solenoid, remove the cover and solenoid, bin the solenoid and silicon the cover back on, done,
if it starts 40D, this is USA / Japan spec in which case you have the shift interlock which stops you cnahging from hi to lo unless in Park or Neutral, if this is the case you need to remove the 4 small bolts holding the 40mm round solenoid, remove the cover and solenoid, bin the solenoid and silicon the cover back on, done,
Dave
www.ashcroft-transmissions.co.uk
www.ashcroft-transmissions.co.uk
Who is online
Users browsing this forum: No registered users and 5 guests