Page 1 of 1
swapping electric chain transfer to manual chain transfer??
Posted: Fri Feb 04, 2005 9:08 pm
by zerosin
can someone tell me if the chain transfer on my g52 (yes mine is a chain bloody sr5) will fit a r150 box...mines a manual shift vs the electronic on the r150 im lookin at
Jarrod
Posted: Fri Feb 04, 2005 11:11 pm
by spazbot
you should have a gear driven transfer behind the g52 ....
transfer case
Posted: Sat Feb 05, 2005 4:26 pm
by toysuzi
hey jarrod
yep what spazbot sed
if you need a hand let me know ill drop around
im only around at medowie
i also have a spare gear tcase & chain tcase if you get stuck
daryl
Posted: Sat Feb 05, 2005 5:12 pm
by zerosin
yeh...wish i had a gear driven...bloody sr5 has chain trainsfer.
thanks for the offer daryl
jarrod
Posted: Sat Feb 05, 2005 5:34 pm
by zerosin
bump..any ideas anyone??
Posted: Sat Feb 05, 2005 6:31 pm
by 4sum4
are you sure its a G52, Thought they were all gear driven
Posted: Sat Feb 05, 2005 7:20 pm
by zerosin
definately a g52 and def. chain
Posted: Sun Feb 06, 2005 12:44 am
by ozrunner
Jarrod
No, not as a straight swapover as the input shaft splines are different.
I had the very same problem wanting to use a new 4cyl electric transfer onto a R series. Refer para 3
Transfer
It can be done by swapping over the input shafts, which is a piece of cake, ie put the R150 electric transfer input shaft into your non electric transfer.
JD
Posted: Sun Feb 06, 2005 7:59 am
by skootin
You can also change the rear g/box housing and go to a gear drive t/fer. You have a 22R in the SR5 I take it.
Posted: Sun Feb 06, 2005 10:17 am
by slosh
The 2.7L petrol Hilux's had G52 box and chain t/case too.
Posted: Sun Feb 06, 2005 6:52 pm
by zerosin
thanks y'all
looks like im lookin for an r150 WITH transfer so i can swap input shafts
Jarrod
Re: swapping electric chain transfer to manual chain transfe
Posted: Sun Feb 06, 2005 11:24 pm
by ozrunner
zerosin wrote:can someone tell me if the chain transfer on my g52 (yes mine is a chain bloody sr5) will fit a r150 box...mines a manual shift vs the electronic on the r150 im lookin at
Jarrod
Jarrod
Mate I assumed you were looking at an R150 that had an electronic transfer
as you mentioned above and needed to know if you could use your non ADD transfer on
this R150.
But now you indicate you are going to look for one
and do the input shaft swap.
If you haven't actually got an R150 with an electric V6 transfer then don't look for one of these
There's no need to swap your input shaft to get a non ADD transfer if you haven't already got an electric transfer.
Just get a R150 with the non ADD chain transfer from an early model RV6 4Runner.
Then sell yours to cut the costs
.
Skootin.
No can do as these gear transfer housings will not directly bolt up to a R series trans. Only way is to use a Marks adapter plate or a USA 86/87 22R EFI housing.
JD
Posted: Thu Feb 10, 2005 6:43 pm
by zerosin
does anyone know what year model RV6 had the manual shift chain case behind the r150??
Posted: Thu Feb 10, 2005 9:46 pm
by toyrex
R150 3.86 1st gear
R151 4.31 1st gear
Posted: Fri Feb 11, 2005 12:50 am
by ozrunner
zerosin wrote:does anyone know what year model RV6 had the manual shift chain case behind the r150??
Definately the 91-94's.
I think it was around 95 Toyota started to fit some of the SR5 extras to RV6's and although I'm not positive some may have also got ADD. If you check the wreckers for 91-94's you should be OK but they will know the difference between ADD and non ADD anyway.
JD