int. light flicker

[chips59]

I have a 2000 GU and when i go around a corner the int. light flickers,
anybody know what it is and how to fix it?

[Ingenious-Eng]

Check all doors are closed properly, the rear barn doors are known for problems, you will need to adjust the catch if they aren't closing tightly.
Cheers.

[chips59]

all doors are closed, and have adjusted barn doors but still does it.
what if i unplug wire to barndoor switch?

[murcod]

sounds like the body is flexing enough to cause a door to open and the door switch to make contact. Like you said above- try disconnecting one door switch at a time until you isolate which one it is.

Could just be a case of sticking a thin piece of rubber where the switch makes contact to push it in a bit further.

The other thing is- have you gat an aftermarket alarm with a tilt sensor or anything like that?

[chips59]

I do have alarm with tilt, may be that. Ill try it.

[murcod]

One of your sensors could be wired into the light circuit alarm I/P (in parallel.)

I did that with a shock sensor on the inlaw's GQ and then had to wire a relay in to disable it's O/P when the ignition was on- otherwise the interior light kept pulsing over bumps etc!!

[ozy1]

we had this prob on the GU, to solve the problem, we added a couple of layers of tape, to the point the switch contacts the door, and this solved it, we tried adjusting the door several time.