Outer Limits 4x4 Board

was wondering if its legal (in NSW) to drive around without a bull bar on

i.e. just the bare chassis

truck is 40 series, and yes the chassis does stick out alot.

and i wanna get the farm gate off it asap, then ill organise some sort of other bar.

is this legal?? and if it isnt, will the bacon really care, it wont be bare for too long i dont think.

cheers

40 lover wrote:was wondering if its legal (in NSW) to drive around without a bull bar on

i.e. just the bare chassis

truck is 40 series, and yes the chassis does stick out alot.

and i wanna get the farm gate off it asap, then ill organise some sort of other bar.

is this legal?? and if it isnt, will the bacon really care, it wont be bare for too long i dont think.

cheers

Dont know about the legalities. But how about just getting the grinder out. Cut up the current 4poster, so all your left with is a bumber.

pretty sure if you are gunna leave the chassis arms hanging out the front of your 40 that in the case of an accident you will end up in jail.......not worth the risk mate.... at the very least you will need to have some sort of protection across the rails.....such as a flat plate or a bit of angle or as suggested cut the current bar up to leave a bumper....

yes you will get thrown in jail.......leave it on till you but a new bar....
make use of it ....grow somepassion fruit or something

Bingham wrote:make use of it ....grow somepassion fruit or something

hahaha!!

ok cheers, i wanna bend up some tube to put on there

hmmm, hard decisions.....

wicked aproach angle..... or..... no wicked aproach angle

someone convince me otherwise before i make some very bad choices

id got to jail, at least you get three solid meals and cable , NOT

If it were me, I'd leave what ever bar I had on there till I got another to replace it. Then do what ever it is you wanted to do with the old one.

Mere

eliteforce32 wrote:id got to jail, at least you get three solid meals and cable , NOT

and free sex, wether you want it or not!

send me a pic or post a pic and I will chop it for you

40 lover wrote:and i wanna get the farm gate off it asap, then ill organise some sort of other bar.

why not leave it on until you sort out another bar?

Tiny wrote:send me a pic or post a pic and I will chop it for you

ok im retarded and havent bothered to learn how to post pics,
pm me your email and ill send it via there, and you can post it up and chop it.... cheers tiny

bogged wrote:why not leave it on until you sort out another bar?

40 lover wrote:wicked aproach angle..... or..... no wicked aproach angle??

and if you know anything about me.... im lazy when it comes to fixing things.

so getting the bar off it, will give me motivation to organise another one to put on.

mmmm... i like the aproach already [/quote]

5mm U channel will fit on very snugly....heres a pic of mine, its just got 4 grade 8 bolts holding it on. Two per side.

40 lover wrote:is this legal?? and if it isnt, will the bacon really care,

Legal? No.
Does bacon care? Yes.

Just wait for your finished, it's not as though your going to get that much more from removing it. If you want I have a nice piece of steel that was to be used as a rear bar for the MQ. It'll do the 40 quite well. You can have it providing you come and pick it up!

thanks heaps for that tiny

i like MY45's design, of the bar just covering the chassis rails,

but my ideas are revolving around that but with tube.