Outer Limits 4x4 Board

gday guys! just wondering if anyone has a detailed pic of the bearing setup for a GQ! reason being, i renewd bearings and brakes on the front of my mav and found a ring just behind the last peice that goes on before the final outer casing with the allan keys in it, it was on the left side but not the right and it made it hard to put the little clip on the holds the last bit on so we didnt bother trying to get it back in instead opting to chuc out the outer ring thingy! when engaged in 4LOW it makes a clunking noise when climbing but when in either 4 or 2 high, its fine! what im guessing is that the shafts have to be in a certain position so as to be able to push the last bit in with the ring in there and put the clip on maybe? and maybe that ring was to stabilize the the second last bit so it doesnt skip teeth? please if anyone knows the trick to it please let me know! thanks guys

ahh u need to have it all in there .. it'll be when ur in 4wd the cv popping in and out of the hub ... not good

You need that little"C" clip on both sides dude.

its not the c clip! you got the c clip, then the hat lookin thingy with teeth inside it and then theres a big thin metal ring that sits on the outer edge! thats the one i threw out

anyone with a detailed diagram?

btt

try this

Bazzle

Edited 2nd Pic added

thanks a shite load bazzle! good stuff now all i got to do is find a wreckers in sydney willing to seperate, its the spacers four back from the c clip!
thanks again dude