i know this has been spoken about b4 but i couldnt find what i was after.
what has to be done to put a 1ltr t/case in a 1.3 WT. i know the tailshaft flanges are different and the early ones dont have a 4x4 switch. what else needs to be done.
are the shifters the same?
can you use the transfer end of the tailshafts and just swap them at the slip joint?
thanx in advance
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
swapping t/cases
swapping t/cases
1999 SQ625 Manual Grand Vitara. Lifted, Twin Locked, 31' Extremes, dual Batteries, Winch.
Lots of custom gear as I cant afford the proper stuff.
Lots of custom gear as I cant afford the proper stuff.
I have done this.
Change the flanges and handbrake from the 1.3 xfer to the 1ltr and you can reuse the same stick in it.
Also have to remove and remount the speedo drive and mounts from chassis, also the 4x4 light. The 1.3 ones fit into the 1ltr ones fine.
cheers
Change the flanges and handbrake from the 1.3 xfer to the 1ltr and you can reuse the same stick in it.
Also have to remove and remount the speedo drive and mounts from chassis, also the 4x4 light. The 1.3 ones fit into the 1ltr ones fine.
cheers
[url=http://www.outerlimits4x4.com/viewtopic.php?p=930942#930942&highlight=]Zook[/url]
U SUK Zook Built and Sold.
New rig is 97 80 DX. 2" list 33s
U SUK Zook Built and Sold.
New rig is 97 80 DX. 2" list 33s
Who is online
Users browsing this forum: No registered users and 1 guest