Page 1 of 1
Single Cab Seats
Posted: Wed May 28, 2003 4:18 pm
by Maddog
My LN106 single cab has a bench and a bucket....I want to ditch the bench and fit a bucket (well 2 buckets from a jap car actually....).
What type of changing of the rails is needed to fit a bucket in the spot of the bench?
Cheers!
Nicko
Posted: Wed May 28, 2003 8:26 pm
by kiwilux
Wouldnt mind betting the holes are there in the floor for the toyota buckets already, my single cab has factory buckets, prob find the surf/4runner ones would go in to with no mods. (wrecker/second hand)
The Sub Imprezza buckets are way cool, they hold ya real good, not sure how they would line up tho in the old luxter
Mike
Posted: Wed May 28, 2003 10:48 pm
by spazbot
some import surfs come with recaro buckets
wrx seat are very nice by at about $400 + each 2nd hand its not worth it
Posted: Thu May 29, 2003 12:19 pm
by vrunner
Just done this on a 79 single cab. I used R32 GTS Skyline buckets which was a mistake! It took 4 hours for the first side (1 1/2 second side) to design and make brackets to suit. Problems I found were that the seats were too wide and would hit the seatbelt reel when aligned centerally with the steering wheel. Overcame this by raising the seat by 30mm. Next problem was that the seat slides are at different hights. I found that the inner slide sits 36mm higher than the outer slide. So when you go to get seats try to get some that have both slides level.
BTW all the holes were already in the floor.