Outer Limits 4x4 Board

Just finally fixed my timing belt and have checked my clearances on valves but need to find out the firing order so we can check it. I cannot find it in my manual. All the clearance specs are their but not the firing order. Does anyone know?

I have a tapping noise that gets worse when I accelerate.

speck should be in the manual some where

as for the tappin noise piston slap or number 4 big end knock perhaps
they were prone to it, the big end knock

need to put a oil press guage on it and compare with the specs to determine a big end knock
or on start up does the oil light take forever to go out?

hey hows it going dur71

firing order is
1342

set up no1 cylinder on TDC
set no1 & no3 valve clearance

then line up no4 cylinder on TDC
& set no2 & no4 valve clearance

its that simple

hope that helps

cheers
daryl

Thanks guys, I'll see how I go.