For those who has the Impco LPG system, it sounds that we all have the A31 air filter sitting on the carby on top of the block all exposed in the engine bay.
I was wondering if anyone has managed to get a sealed box for the filter? I am asking because I wanted to put a snorkel ( rear facing ) for water crossings.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
LPG A31 Airboxed??
God of Magnificant Ideas!
know this drama real well. 
fixed it with a "BOILERS POT"
shop around the St Vinnys shops etc for an old boiling pot that is large enough to give around 2 inches of clearance to the air filter....
cut a hole in the bottom the same as the coverplate of the mixer and drill the bolt holes to match
trim the sides to a height you need so the the thing sits as close as posiable to the inlet manifold
this is mine on a 308 in a Patrol....cost me 1/2 an hour to do and the pot cost $3.00
Ive done rivers up to 5' deep and as you can see it gets plenty of mud action
The one in the pic is a steel job.....
the new one on the Chev is alloy >>>>>> bling bling
Kingy
fixed it with a "BOILERS POT"
shop around the St Vinnys shops etc for an old boiling pot that is large enough to give around 2 inches of clearance to the air filter....
cut a hole in the bottom the same as the coverplate of the mixer and drill the bolt holes to match
trim the sides to a height you need so the the thing sits as close as posiable to the inlet manifold
this is mine on a 308 in a Patrol....cost me 1/2 an hour to do and the pot cost $3.00
Ive done rivers up to 5' deep and as you can see it gets plenty of mud action
The one in the pic is a steel job.....
the new one on the Chev is alloy >>>>>> bling bling
Kingy
You do not have the required permissions to view the files attached to this post.
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Who is online
Users browsing this forum: No registered users and 2 guests